E: info@deltapanels.com    W: www.deltapanels.com
Head Office: 731 Boundary Road, Richlands, Qld 4077  |  P: +61 7 3271 2170  
Sydney Depot: 11 The Old Northern Road, Narellan, NSW 2567  |  P: +61 2 4611 7712
ABN: 11 147 861 292
   Page: 21 of 126
Version Date: 2025-12-29
COMPONENTS:
Flashings
Flashings unless otherwise noted are to be made from 0.55mm 
steel and installed to AS 1562.1:2018. Aluminium can be used 
but referral to IPCA for cold storage compliance is advised.
12. INSTALLATION - FASTENERS,  
      FLASHINGS, FOAM INFILLS STRIPS  
      AND SEALANTS
Foam Infill Strips
Butyl Rubber Adhesive Tape 
for Metal Roofing
Sealant for Metal Roofing
The sealant should be of neutral cure and meet the recommendations 
as outlined in BlueScope TB-9 Sealants for Exterior Finishes.
FM Approvals
For full installation details please visit FM Approvals RoofNav site - www.fmapprovals.com/RoofNav
11. INSTALLATION - FACTORY MUTUAL  
      INSTALLATION REQUIREMENTS -  
      PR 459387
To comply with the Factory Mutual Accreditation PR459387 
the following conditions must be followed.
DeltaTrim-TPC™, DeltaOrb-TPC™ & DeltaCorroCorro-TPC™ 
Installation Requirements
Installation Detail
Fastening System A
Through-fastened with EJOT JT2-D-6-5,5/6,3xL fasteners spaced 250 mm (9.8 in) on 
center at each support. Stitch screw EJOT COLORFAST CF15 SF 6,3x25 every 250 mm 
(9.8 in) on overlapping seams.

View this content as a flipbook by clicking here.