E: info@deltapanels.com    W: www.deltapanels.com
Head Office: 731 Boundary Road, Richlands, Qld 4077  |  P: +61 7 3271 2170  
Sydney Depot: 11 The Old Northern Road, Narellan, NSW 2567  |  P: +61 2 4611 7712
ABN: 11 147 861 292
   Page: 19 of 126
Version Date: 2025-12-29
Equipment Recommendations
•	
Personnel cutting panels should always wear safety glasses, gloves and long sleeve 
shirts. 
•	
Panel cutting should take place prior to installation when possible.
•	
Use care when using saws to avoid panel delamination; make sure the blade is 
sharp and let the saw cut at its own pace - do not force. 
•	
Use the following cutting tools to avoid panel damage: 
	
o
Circular Saw with metal cutting blade or panel thumper blade
	
o
Nibblers
	
o
Panel saw
•	
The use of abrasive saws/grinder blades will damage the paint finish and metal facings 
•	
For small penetrations, cut each panel face with a portable router, then cut the foam 
with a serrated knife.  Metal flashings may be cut with power snips, nibblers or hand 
snips. 
Cutting Recommendations
•	
Place the panel on padded sawhorses.
•	
Clean any surface grim and debris off panel face to be cut 
with clean rag.
•	
Mark cut line with chalk or washable felt tip marker.
•	
Masking tape may be applied on both sides of cut line to 
minimize panel scratching. 
•	
Recheck measurements and cut with appropriate tool.
•	
Remove burrs at cut edges with deburring tool. 
9. INSTALLATION - PANEL CUTTING

View this content as a flipbook by clicking here.