Delta Panels Pty Ltd - ABN: 11 147 861 292
P: +61 07 3271 2170    
E: info@deltapanels.com   
W: www.deltapanels.com    
Head Office: 731 Boundary Road, Richlands, Qld 4077
Sydney Depot: 11 The Northern Road, Narellan, NSW. 2567    
Page 7 of 8 
Version Date: 2025-10-15
STEP 6 - DETERMINE THE REQUIRED CABLE LENGTH
STEP 5 - MOUNT THE LED DRIVER
•	
Mount the LED driver at the fixing points on the back of the 
product case.
•	
It’s recommended that the LED driver is mounted in the roof 
cavity in an easy to access location.
•	
For a Stand Alone structure where it is not possible to mount 
the LED driver in the roof cavity it is recommended to place 
the device behind the rear barge capping.
•	
Measure the distance from the position of the LED light to the 
LED driver and determined the length of cable required.
•	
The LED Light assembly comes with a both 6 metre and a 3 
metre cable and can be configured to reach 9 metres.
STEP 7 - CONNECT CABLE TO THE LED DRIVER
•	
Once the required cable length is determined and the cable 
combination is created, attach the cable to the LED driver by 
the Thread-Lock Cable Joiner.
STAND ALONE MOUNTING OF LED DRIVER
STAND ALONE MOUNTING OF LED DRIVER
STEP 8 - RUN THE CABLE AND CONNECT TO THE LIGHT
•	
After connecting the cable to the LED Driver run the cable along 
the cable recess track on the edge of the Panel.
•	
Make a track from the cable recess track to the light cut-out recess 
and then pull the cable through to the cut-out recess
•	
Connect the light and the cable by the Thread-Lock Cable Joiner.

View this content as a flipbook by clicking here.