E: info@deltapanels.com Head Office: 731 Boundary Road, Richlands, Qld 4077 +61 7 3271 2170 W: www.deltapanels.com Sydney Depot: 11 The Old Northern Road, Narellan, NSW 2567 +61 02 4611 7712 ABN: 11 147 861 292 Version Date: 08.05.2023 6 GLOSSARY DeltaSpan™ A registed name covering the range of Delta Panels™ insulated roofing products, DeltaTrim™, DeltaOrb™, DeltaCorroCorro™, DeltaTrimTrim™ & DeltaTrimCorro™ DeltaTrim™ A registered name for Delta Panels™ insulated roof product with a trapezoid formed top skin DeltaOrb™ A registered name for Delta Panels™ insulated roof product with a corrugated formed top skin Insulated Roofing Covers all the products listed in DeltaSpan™ Single Span The length between two fixing points Multi Span A continuous length that spans over three (3) or more fixing supports Roof Span Being the total span of the roof area with any overhang included Gable KingPost A Gable roof construction where the roof panels are attached to the ridge beam via a connecting channel Gable KingPost-ECO A Gable roof construction where the roof panels are placed upon the ridge beam and fixed directly through the panel Overhang The length that the roof sheeting overhangs the last fixing support, forming a cantilevered portion Roof Slope The angle of the roof from its peak to its lowest point Cyclonic Region Refer to Step 1 Wind Speed Determination NonTrafficable Not designed for direct foot traffic and requires a temporary walkway for maintenance access. NonCyclonic Region Refer to Step 1 Wind Speed Determination Beam Load Widths The width of the roof which is considered to act in loading the beam for simple awnings this is 50% of the roof sheeting plus any adjacent overhang Uplift Loads on the Beam Is determined by a combination of the following factors, Beam Load Width, Awning Style and the Wind Category Post Load Widths The width of roof which is considered to act in loading the post. For simple awnings this is 50% of the roof sheeting plus any adjacent overhang that loads the beams connecting to the post Uplift Loads on the Post Is a force that consists of a combination of uplift force on the beam and the load width of the post Hold Down Capacity The maximum uplift capacity that the foundation can resist SHS Post Is a commonly used term for a Square Hollow Section steel post C-section Beam Is a commonly used term for a rollformed cold formed C section steel beam DeltaBeam™ A registered name for Delta Panels™ two (2) piece roll-formed beam (RFB) Receiver Channel A roll formed channel that is attached to an existing structure into which the roofing sheet is then fixed
View this content as a flipbook by clicking here.