Glen Gugliotti – CMI Don Grehan – Unrestricted Building Certifier Date of issue: 09/05/2025 Date of expiry: 11/05/2028 Certificate number: CM40346-I02-R00 This certificate is only valid when reproduced in its entirety. Page 1 of 6 Certification Body: ABN: 81 663 250 815 JAS-ANZ Accreditation No. Z4450210AK PO Box 273, Palmwoods Qld 4555 Australia P: +61 7 5445 2199 www.cmicert.com.au office@cmicert.com.au Certificate Holder: Delta Panels Pty Ltd ABN: 11 147 861 292 731 Boundary Road, Richlands, QLD, 4077 Australia Ph: 07 3271 2170 www.deltapanels.com.au Certificate number: CM40346 THIS IS TO CERTIFY THAT Delta MW and EPS Panel Class 10a Awning and Patio Roof System Type and/or use of product: To be used for Class 10a Awning and Patio structures that are attached or adjacent to a Class 1a building that run parallel with a side boundary and is within 900mm of that side boundary. Description of product: Delta MW and EPS Panel Class 10a Awning and Patio Roof System incorporates DeltaTrim-MW or DeltaOrb-MW Panels (within 900mm of the boundary) and DeltaOrb™ EPS-FR or DeltaTrim™ EPS-FR panels of the same thickness and profile for the remaining section of the structure. Refer A2. COMPLIES WITH THE FOLLOWING BCA PROVISIONS AND STATE OR TERRITORY VARIATION(S) BCA 2022 Volume One Volume Two Performance Requirement(s): Not Applicable H3P1(1) Contributes to the Spread of fire subject to Limitation and Condition 1 Deemed-to-Satisfy Provision(s): Not Applicable Not Applicable State or territory variation(s): Not Applicable Not Applicable SUBJECT TO THE FOLLOWING LIMITATIONS AND CONDITIONS AND THE PRODUCT TECHNICAL DATA IN APPENDIX A AND EVALUATION STATEMENTS IN APPENDIX B Limitations and conditions: 1. Compliance with H3P1(1) is subject to site specific performance solution to the satisfaction of the Appropriate Authority as described by the NCC. 2. The Delta MW and EPS Panel Class 10a Awning and Patio Roof System is only to be used as a Class 10a Awning and Patio structure. 3. In the absence of a site-specific performance solution, this system must not be used to facilitate the exemptions for a carport specified in Part 9.2.8 Open carports of the ABCB Housing Provisions. 4. Construction shall be in strict accordance with A5 of this Certificate of Conformity. 5. Compliance with H3P1(1) is dependent on the system as specified in A3. Any deviation from the described system does not form part of this Certificate of Conformity. 6. The structural support members are designed and engineered separately as per project requirements by building designers and engineers. 7. The use of the certified product/system is subject to these Limitations and Conditions and must be read in conjunction with the Scope of Certification below. Building classification/s: Class 10a Scope of certification: The CodeMark Scheme is a building product certification scheme. The rules of the Scheme are available at the ABCB website www.abcb.gov.au. This Certificate of Conformity is to confirm that the relevant requirements of the Building Code of Australia (BCA) as claimed against have been met. The responsibility for the product performance and its fitness for the intended use remain with the Certificate Holder. The certification is not transferrable to a manufacturer not listed on Appendix A of this certificate.